Insert plastic and light alloy fixing solutions
Unheaded pressed-in insert for pressing into thermoplastics and thermosets.
| Advantages |
|---|
| ▸ 45° knurl reduces radial loads during installation |
| ▸ Thinner boss walls |
| ▸ Pilot point to facilitate positioning |
| Part Number | Thread M (6H) | L (mm) | Ø E (mm) | Ø B (mm) | Well Ø (mm) | Recommended min. wall thickness (mm) | 3D |
|---|---|---|---|---|---|---|---|
| IP 1 025 053 R042 L 0 | M2.5 X 0.45 | 5.3 | 4.2 | 3.7 | 3.8 | 2.5 | |
| IP 1 030 053 R042 L 0 | M3 x 0.50 | 5.3 | 4.2 | 3.7 | 3.8 | 2.5 | |
| IP 1 040 074 R058 L 0 | M4 X 0.70 | 7.4 | 5.8 | 5.3 | 5.4 | 2.7 | |
| IP 1 050 083 R066 L 0 | M5 x 0.80 | 8.3 | 6.6 | 6.1 | 6.2 | 3 | |
| IP 1 060 092 R082 L 0 | M6 X 1.00 | 9.2 | 8.2 | 7.7 | 7.8 | 3.4 | |
| IP 1 080 092 R097 L 0 | M8 x 1.25 | 9.2 | 9.7 | 9.3 | 9.4 | 3.8 |
Push in the insert, preferably with a press, not a hammer.
The insert is forced into a hole, without impact or bouncing, by axial pressure in a press with a punch.
The insert rotates slightly in the direction of the knurling. The punch must be smooth to allow the insert to rotate.
The insert must be held axially, since any inclination will result in radial loads which may damage the material.
Under the effect of the insert, the plastic deforms and takes the specific shape of the insert, thereby guaranteeing good torque resistance and holding force.
Quote & Information
