▸ | Very high torque resistance and holding force |
▸ | Assembly in hidden time possible |
▸ | Suitable for plastic rotational moulding and injection |
▸ | Various outer shapes |
▸ | Very high torque resistance and holding force |
▸ | Assembly in hidden time possible |
▸ | Suitable for plastic rotational moulding and injection |
▸ | Various outer shapes |
▸ | Very high torque resistance and holding force |
▸ | Assembly in hidden time possible |
▸ | Suitable for plastic rotational moulding and injection |
▸ | Various outer shapes |
▸ | Very high torque resistance and holding force |
▸ | Assembly in hidden time possible |
▸ | Suitable for plastic rotational moulding and injection |
▸ | Various outer shapes |
▸ |
▸ | Assembled and removed using an Allen wrench with the same dimensions as the hexagonal hole |
▸ | Shorter assembly and removal times |
▸ | Optimised thread favouring plastic flow during installation |
▸ | Eco-design, 100 % recyclable |
▸ | Assembled and removed using an Allen wrench with the same dimensions as the hexagonal hole |
▸ | Shorter assembly and removal times |
▸ | Optimised thread favouring plastic flow during installation |
▸ | Available in split version with cutting slot on request only |
▸ | Post-moulding installation |
▸ | High holding force |
▸ | Post-moulding installation |
▸ | High holding force |
▸ | Post-moulding installation |
▸ | High holding force |
▸ | Post-moulding installation |
▸ | High holding force |
▸ | Post-moulding installation |
▸ | High holding force |
▸ | Straightforward and quick manual installation |
▸ | Very sharp teeth for improved penetration of material |
▸ | Low cost |
▸ | Locking improves torque resistance and holding force |
▸ | Straightforward and quick manual installation |
▸ | Very sharp teeth for improved penetration of material |
▸ | 45° knurl reduces radial loads during installation |
▸ | Thinner boss walls |
▸ | Pilot point to facilitate positioning |
▸ | 45° knurl reduces radial loads during installation |
▸ | Thinner boss walls |
▸ | Pilot point to facilitate positioning |
▸ | Clean and fast ultrasonic or heat-transfer installation |
▸ | 45° cross knurl increases torque resistance and holding force |
▸ | Clean and fast ultrasonic or heat-transfer installation |
▸ | 45° cross knurl increases torque resistance and holding force |
▸ |
SECAM is your partner for more than 50 years for engineering and industrialization of your inserts for plastics, light alloys and wood. We stock over 300 references covering our traditional available in stock.
Documents
Applicable documents and agreements issued by the union of ARTEMA bindings manufacturers
Quote & Information