Headed
30° knurl reduces radial loads during installation
Pilot point to facilitate positioning
Thinner boss walls
- 30° knurl reduces radial loads during installation
- Thinner boss walls
- Headed
- Pilot point to facilitate positioning
Fasteners Engineering
Large Series – E-Shop
| Part Number | Thread M (6H) | L (mm) | Ø E (mm) | Ø B (mm) | Ø C (mm) | H (mm) | Well Ø (mm) | Recommended min. wall thickness (mm) | Technical sheet | 3D |
|---|---|---|---|---|---|---|---|---|---|---|
| IP 2 030 059 R055 L 0 | M3 X 0.50 | 5.9 | 4.2 | 3.7 | 5.5 | 0.58 | 3.8 | 2.5 |  | |
| IP 2 040 083 R071 L 0 | M4 x 0.70 | 8.3 | 5.8 | 5.3 | 7.1 | 0.89 | 5.4 | 2.5 | | |
| IP 2 050 094 R079 L 0 | M5 X 0.80 | 9.4 | 6.6 | 6.1 | 7.9 | 1.07 | 6.2 | 2.7 | | |
| IP 2 060 105 R095 L 0 | M6 x 1.00 | 10.5 | 8.2 | 7.7 | 9.5 | 1.32 | 7.8 | 3 | | |
| IP 2 080 105 R111 L 0 | M8 X 1.25 | 10.5 | 9.7 | 9.3 | 11.1 | 1.32 | 9.4 | 3.4 | |
Pressed-in insert – Type 2 headed
Phase
01
Push in the insert, preferably with a press, not a hammer.
The insert is forced into a hole, without impact or bouncing, by axial pressure in a press with a punch.
Phase
02
The insert rotates slightly in the direction of the knurling. The punch must be smooth to allow the insert to rotate.
The insert must be held axially, since any inclination will result in radial loads which may damage the material.
Phase
03
Le plastique sous effet de l’insert se déforme pour fluer dans le profil spécifique de l’insert et ainsi permettre une bonne tenue au couple et à l’arrachement.
Product |
Sub-family |
Type |
Thread |
L |
Outer Shape |
Ø E |
Materials |
Specification |
|||||||
Example |
I |
P |
1 |
0 |
2 |
5 |
0 |
5 |
3 |
R |
0 |
4 |
2 |
L |
0 |
|
Insert |
Pressed-in |
Headless |
Internal thread |
Total length 5.3 mm |
Round |
Largest diameter 4.2mm (1/10mm) |
Brass CW 614N |
None |
|||||||
| Sub-families U Ultrasonic V Screw S Moulded-in E Expansion P Pressed-in |
Pressed-in insert type Outer shape |
Materials |
Specifications 0 none 1 ZnNi Zinc Nickel N Nickelage |
